Generally PASS punching tools are made of special alloyed steel to fullful the highest punching demands. Furthermore we attach great importance to a high quality hardening process by repeated temporing and deep-freeze subsequently.
Customers often ask: "We have 120.000 hits to punch in a stainless steel with sheet-thickness of s=3mm. How many punches do we need?" or "At what quantity of hits should we regrind our tools?" Unfortunately the answers to all these questions are not easy to make as a lot of different factors...
Each tooling system is equipped with special design styles. So sometimes it can be difficult to disassemble and reassemble these special tooling designs. Therefore we have compiled a list of assembly instructions regarding tool positions P2 - P10 for the PASS Salvagnini tool systems
This special design to be used with Emboss Tools are normally produced with spring loaded die and also for machines without active die or without ram from below. However, there is always the problem that scratches appear on the bottom part of the sheet due to the heightened base of the tool as...
