.search

  .faq .calculations .calculation of maximum diameters/shape  

 

Calculation of maximum diameters/shape

Please find below some formulas to calculate the maximum diameter or shape diagonal that will fit on the punch (MD = Maximum Diameter).
illustration

    
1.) Round -> MD = D
illustration

  
2.) Square -> MD = a xWurzel aus 2
illustration

  
3.) Square with radius -> MD = (a - 2 x R) xWurzel aus 2+ 2 x R
illustration

  
4.) Rectangle -> MD =Wurzel aus a im Quadrat plus b im Quadrat
illustration

  
5.) Rectangle with radius-> MD=Wurzel aus Klammer auf a minus 2 mal R Klammer zu im Quadrat plus Klammer auf b minus 2 mal R Klammer zu im Quadrat+ 2x R
illustration

  
6.) Obround -> MD= b
illustration

  
7.) Hexagonal -> MD= SW x1 durch Cosinus mal 30 Grad
or -> MD= SW x 1,155
illustration  
8.) Cross Forms-> MD=Wurzel aus a im Quadrat plus b im Quadrat

If you have any further questions please do not hesitate to
contact our sales engineers.

 

 
     
17.04.2012
BIAM 2012		  
   
  International Exhbition for machines and tools

» Read more...		  
06.06.2011
PASS Knock-Out Technology		  
   
  In the daily life, installers and electricians are confronted with the challenge to position cables in the correct position of an electrical...

» Read more...		  
26.10.2010
PASS Step Plate Tool		  
   
  Step plates can particulary be found in construction of vehicles, waggon or shipbuildings, for bridges and ramps.

» Read more...		  
PASS Punch & Die Inc.   .P.O. Box 70   .USA 49333 Middleville, MI   .Phone 800-546-9340   .Fax 269-865-6200   .email: sales@pass-usa.com .imprint    .terms    .sitemap