Assembly Instructions
P2, P4, P5, P6, P7, P9, P10

Each tooling system  is equipped with special design styles.

Sometimes it can be difiicult to disassemble and reassemble these special tooling designs.

Therefore we have compiled a list of assembly instructions regarding tool positions P2 - P10 for the PASS tools of tooling system Salvagnini.

Examples:

Assembly Instruction P7 - System Salvagnini

Lightly grease the inside of the guide and place the punch insert from the top into the punch guide.		Insure punch insert seats solidly on the base.		Attach the snap-ring
with the aid of circlip pliers		into the deep lying slot.		Place pressure disc followed by blue pressure spring Ø 25x25 and finally the head into the guide.
Insure the punch head is at position 0 or 90°.		Insert the assembly pin laterally through the guide into the punch shoulder. This is important to avoid damaging the cutting part edge of the punch when tightening the screw.		Lock the screw M8 with approx. 30 Nm uwith the aid of a bench vice. Remove the assembly pin.

Assembly Instruction P9 - System Salvagnini

Place the pressure disc, than the blue pressure spring Ø25x25 and finally the punch head from the top over the punch shank		and tighten the barrel head screw M6 with approx. 15 Nm with the aid of a bench vice.		Place this asslembly into the lighty greased punch guide
and place the special snap-ring		over the head.		Clamp with the aid of the assembly adapter
the tool axial into the bench vice and compress to a total length of approx.100 mm.		Push the snap-ring with a screw driver into the designated slot of the punch guide.

Below you have the possibility to download the complete Assembly Instructions of P2 - P10 for tooling system Salvagnini: